OBDDiag Toyota Pro

OBD II App that will communicate with your Toyota Engine ECU Vehicles. The Generic OBDII is also included and will work with any OBD II Complaint Vehicle. The app requires OBDII ELM 327 Bluetooth(See Below). It will read Toyota Enhance/Extended PIDS(130 PIDS available) and Perform Output Test (70 PIDS available). Not all of the PIDS are supported by the vehicle. It will support certain ranges of Toyota Models and Years (2000-2006 Toyota). It may work on some of the Lexus Models.

ATTENTION: Try Free "DIAG MY TOYOTA" Before Purchasing this App.

If it works, then you may take advantage with the Pro version which includes Output Test, Nicer GUI, Better Support, and more features will be added.

Currently, It will Support ISO-9141 PROTOCOL ONLY for the Enhance Toyota! CAN BUS is Not Supported for the Enhance Toyota!

The Generic OBDII supports all of the Protocols.

-----------------------------------------------------------
The App Supports the Following (ISO-9141)
-----------------------------------------------------------
* Enhance Data Parameters
* Output Test
* Mode 3 - Read Faults
* Mode 4 - Clear Faults
* Mode 7 - Pending Faults

* Generic Data Parameters (Any OBD II Complaint Vehicle)
* Readiness
* O2 Sensor Location
* Mode 2 - Freeze Frame Data
* Mode 3 - Read Current Faults
* Mode 4 - Clear Faults
* Mode 6 - On-board Test Result
* Mode 7 - Read Pending Faults
* Mode 9 - VIN, Performance Tracking Data, ECU Name, Calibration and Verification ID
* Mode A - Read Stored Faults

Will be supporting more features in the future release.

Output Test parameters is not filtered thoroughly and some of the Output Test will not work, because the ECU does not support it.

Toyota Enhance Powertrain: Tested successfully on the following vehicles
* 2004 Toyota Camry
* 2002 Toyota Camry Solara

Disclaimer Notice:

Do not attempt to enter information or adjust your device while driving. Failure to pay full attention to the operation of your vehicle could result in death, serious injury, or property damage. You assume total
responsibility and risk for using your device with this app.

HARDWARE REQUIREMENT: ELM 327 OBD II Bluetooth Device with Blue/Orange Color Tag and Black Color Case from Ebay or Amazon.
Update: CHX, OBDII, Vgate Bluetooth Device tested ok.