IOS command with examples 2 goThis is a new improved version of the application IOScomm.Previous applications supported routers only, and in the future will not be upgraded.It is recommended that you uninstall the old version of the application and set a new one (although both will work independently at the same time).IOScommands covers Cisco routers and switches.For routers, covered the following areas: 1. GENERAL 2. ROUTING-GENERAL 3. ROUTING-STATIC 4. ROUTING-RIP 5. ROUTING-EIGRP 6. ROUTING-OSPF 7. INTER VLAN ROUTING 8. PPP 9. FRAME RELAY10. SECURING THE ROUTER411. CDP COMMANDS12. IP COMMANDS813. IPX COMMANDS14. ACCESS LISTS15. DHCP16. NAT17. IP v618. WAN CONFIGURATIONS19. TROUBLESHOOTING TOOLSFor switches, covered the following areas: 1. GENERAL 2. CONFIGURE IP CONNECTIVITY 3. CONFIGURE A WEB INTERFACE 4. BACKING UP A CONFIGURATION 5. DHCP SNOOPING 6. CONFIGURING PORT SECURITY 7. VLAN CONFIGURATION 8. CONFIGURE THE NATIVE VLAN 9. DTP TRUNKING MODES10. VLAN FOR VOICE11. VTP – VIRTUAL LAN TRUNKING PROTOCOL12. STP – SPANNING TREE PROTOCOL